Configuring the Linksys WRT54G v8.0
 

 
Logging In   |   Setup Tab   |   Wireless Tab - Basic   |   Wireless Tab - Security

Security Tab   |   Administration Tab
 

 
Logging in to the Linksys WRT54G v8.0

Photo of Image001

Open your browser and in the address bar type in 192.168.1.1
Username: admin
Password: admin

Back to Top

 
 

 
 
Setup Tab - Under Basic Setup:

Photo of Image002

Change the Internet Connection Type to: Static IP

Add your Internet IP Address: IP ASSIGNED BY NEMONT
Add your Subnet Mask: SUBNET MASK ASSIGNED BY NEMONT
Add your Gateway: GATEWAY ASSIGNED BY NEMONT
Add your DNS1: 216.129.224.1
Add your DNS2: 216.220.0.1
Add your DNS3: 216.220.30.1

Change the Router Name to: YOUR NAME
Change the Time Zone to: YOUR CURRENT TIME ZONE
Click Save Settings then click Continue on the next page.

Back to Top

 
 

 
 
Wireless Tab - Under Basic Wireless Settings:

Photo of Image003

Change Wireless Network Name (SSID) to: CUSTOMER NAME
Click Save Settings then click Continue on the next page.

****** NOTE *****
If you are programming the modem via wireless instead of Ethernet, please refer to the following instructions:
Once you change the SSID name to something else, you will have to reconnect to the wireless network via the new SSID name. This will also require you to log back in with the username and password in the above steps.

Back to Top

 
 

 
 
Wireless Tab - Under Wireless Security:

Photo of Image004

Change Security Mode to: WPA PERSONAL
Change WPA Algorithm to: TKIP
Change WPA Shared Key to: SERIAL NUMBER ON THE BOTTOM OF THE LINKSYS
***** (NOT MAC ADDRESS) *****

Click Save Settings then click Continue on the next page.

Back to Top

 
 

 
 
Security Tab - Under Firewall:

Photo of Image005

Uncheck the box labeled: Block Anonymous Internet Requests
Click Save Settings then click Continue on the next page.

Back to Top

 
 

 
 
Administration Tab - Under Management:

Photo of Image006

Change the Password to: nemontadmin
Change the Re-Enter to Confirm Password to: nemontadmin

Change Remote Management to: Enabled
Make sure Management Port is defaulted to: 8080

Click Save Settings then click Continue on the next page.

Congratulations, you are done setting up basic settings on your new Linksys WRT54G version 8.0.

** NOTE **
If you have your own network, you will need to contact technical support for assistance with getting it on FTTP if it does not work after adding your network to our Linksys. If the you have a Linksys of your own please contact technical support once our Linksys is up and working.

Back to Top